Adding Wear Measurements using the Web Software

For those using the web software to add belt wear measurement results, we have recently made life a bit easier for you.

In the past, it was necessary to click on each result box to enter a result for that X coordinate. Or you could use the tab key, which required a few keystrokes to get to the right field. We received feedback from customers that they found this a bit annoying, as well as time consuming.

We took this on board and now, after clicking in the first result field and entering the results, you can hit the enter key and the cursor will jump to the next field. You can keep doing this for all the result fields in the table. Hopefully you will find this beneficial.

Unless you are using the ipad, then you don't have to go near the pc!

Adding_Wear.jpg

prev next
Was this article helpful?
0 out of 0 found this helpful

Articles in this section

prev next

Related sections