Creating a wear test

On the toolbar, click on the Plus web_icons_plus.PNG icon to create a new wear test, click on the Cancel web_icons_cancel.PNG icon to cancel without saving.

web_wear_tests.PNG

Select the required test Type, enter the Test Date and test details and click Save.

web_wear_create.PNG

On the Results toolbar, click on the Plus web_icons_plus.PNG icon to BuildCopy or Clear a results grid.

web_wear_create_results.PNG

For building a grid, enter the Start X value (the starting point) where the first measurement will be measured. Enter the End X value (the ending point) where the last measurement will be measured. Enter the required Increment By value, which is the distance between measurements.

Enter the required Y Locations. Y locations are readings along the same belt section. If only testing on one location, enter 1. Multiple Y locations may be required if multiple tests are to be conducted on the same section of belt on the same day. This is to ensure accurate forecasting. To add multiple locations, type comma separated values, for example, to create three Y locations, enter "1,2,3".

Click on the Build button, or Cancel to go back.

web_wear_build_grid.PNG

Copying a grid will duplicate the grid from the previous test.

Click into the Result cell of any row to update/edit it, hit the Enter key to navigate through the results, enter the required Result, tap Valid (switch from unticked to tick) to mark a result invalid.

web_wear_results.PNG

Click the Save button to save the test and the results.

prev next
Was this article helpful?
0 out of 0 found this helpful

Articles in this section

prev next

Related sections