Adding a Wear Measurement to a Liner

Select the required Liner/s to be measured on the chute layout. The Wear Management button will now be activated blue allowing it to be selected.

ipad_liners_add_wear_1a.jpg

Select Type (of measurement) from the drop down (e.g. Top of Liner Thickness). Select Create Test.

ipad_liners_add_wear_2a.jpg

Add the Result and other information as required. Select the tick to save.

ipad_liners_add_wear_3a.jpg

The result is shown in the table. Select the next liner/s to continue.

ipad_liners_add_wear_4a.jpg

prev next
Was this article helpful?
0 out of 0 found this helpful

Articles in this section

prev next

Related sections