Adding Idler Configurations to Conveyors

When creating an idler failure on the web or the mobile app, a selection of idler configurations are presented in graphical form. In order to make it easier for those doing the inspection, only the idler configurations used on that conveyor should be shown on the Create Idler Failure screen. This configuration can only be done by Business Administrators.

Click on the hamburger menu and select Idler Management from the Products menu, and System Administration from the System Settings menu.

New_30_Bus_admin_1.jpg

Select Tag Customisation under Idler Management.

New_30_Bus_admin_2.jpg

In the example below, idlers are configured at the Business level. This means that the selected sets will be available for ALL conveyors on site as the default.

New_30_Bus_admin_3.jpg

In the example below, idlers are configured at the Business level. This means that the selected sets will be available for ALL conveyors on site as the default. To set it at a lower level, makes selections from the Group, Department and Area dropdowns as required.

New_30_Bus_admin_4.jpg

 

prev next
Was this article helpful?
0 out of 0 found this helpful

Articles in this section

prev next

Related sections